Dial Number; Phone Book - Volkswagen Zubehör Touch Phone-Kit Music Mode D'emploi

000 051 473 C BA Touch Phone-Kit Music.book Seite 85 Freitag, 24. Februar 2012 8:04 20

7.2 Dial number

If you want to dial a number you must first start the voice control system and then say Dial number.
When speaking a telephone number it is advisable to divide the telephone number into short number
groups containing 3 - 4 numbers as you say them. If you make a short break after you spoke a group of
numbers, the last entry will be repeated and a signal will be sounded afterwards so that you can continue
speaking the number.
After you have announced the last number in the telephone number you can give the Repeat command
so that you can check the number as it is repeated back to you.
Now say Dial to establish the connection.
Voice commands in the "Dial number" menu:
Repeat
Delete all
Delete last
Dial
Delete group

7.3 Phone book

If you want to dial a number from the telephone book you must first start the voice control system and
then say Telephone book.
The first phone book entries are displayed on the screen after the phone book has opened. Use the Next,
Next page, Previous and Previous page voice commands to page through the telephone book.
Once you are in the phone book you can use the Fast search voice command to skip to a specific initial
letter in the phone book. A list starting with the initial letter that numbers can be called from will then be
displayed on the screen. Say the desired letters in sequence. Only those letter combinations are able to
be selected which match the stored entries. If the entries should be displayed, please say Select.
Every entry within the telephone book can be selected via a voice command (e. g. calling Max
Mustermann).
Use the Read list voice command to have the telephone book entries read out. It will start with the first
phone book entry that is displayed on the screen. You can use the Repeat voice command during the
reading process to have the last entry read out again and you can then use the Stop voice command to
stop the currently spoken entry.
The list entries can be selected by speaking the displayed number (1-6) out loud.
Use the Dial voice command to establish the connection for the selected telephone number. If several
call numbers have been assigned to a telephone book entry you will be asked which call number should
be dialled before the connection is established, e. g. Private or Mobile.
Alternatively you can open the selected phone book entry using the Dial voice command. All the stored
telephone numbers for the telephone entry which has been opened will be displayed with den any
additional information which may have also been stored (dependent on the mobile telephone itself).
Establishing the connections with all of the displayed telephone numbers can be started by using the
relevant voice command, e. g. Private or Mobile. Give the Number voice command and all of the existing
telephone book entries will be read out or say Voice command to hear the saved voice commands or use
one (see Chapter 7.1 Voice command).
85
The telephone number or the previous entry will be repeated.
Deletes the complete entry.
Deletes the last entry.
Establishes a connection for the entered telephone number.
Deletes the last group of numbers that was entered.