Parkside PSHL 2 A1 Traduction Du Mode D'emploi D'origine page 10

Safety instructions
of the device and understand
the associated risks. Do not
allow children to play with the
product. Cleaning and user
main tenance should not be
performed by children without
supervision.
The welding helmet with auto-
„ z
matic darkening is not suitable
for laser and gas welding.
Never place the welding
„ z
helmet on hot surfaces.
Never open the welding
„ z
helmet. Never carry out repairs
on or modifications to the
welding helmet. These may
only be carried out by trained
experts.
Please ensure that you have set
„ z
the automatic darkening before
each welding procedure.
The safety visor should not be
„ z
opened. It protects the filter
from dirt and damage.
If the filter does not
„ z
automatically darken, then
immediately end the welding
procedure and contact the
manufacturer.
Only use the welding helmet
„ z
in temperatures between -5 °C
and +55 °C. The filter's reac-
tion time will slow down if this
temperature has not been
reached or is exceeded.
10 GB/IE/NI
Clean the filter, the surface of
„ z
the helmet and the solar cells
regularly.
Replace the protective visor if
„ z
scratches or damages appear.
The welding helmet does not
„ z
provide protection against
impact.
Frequent use, cleaning or
„ z
storage can mean that the
service life is less than 6 years.
Replace the welding helmet
immediately if the viewing
panel gets scratched or the
viewing panel is visibly
damaged in any other way.
ATTENTION! Materials
that come into contact with the
wearer's skin may cause allergic
reactions in people with sensitive
skin.
ATTENTION! Eye protection
can represent a hazard for the
wearer if it is worn over normal
corrective glasses due to the
impact from high-speed particles.
ATTENTION! If protection
against high-speed particles at
extreme temperatures is required,
the eye protection chosen must be
labelled with the letter T directly
after the letter for the impact