Cleaning And Maintenance; Storage; Environmental Instructions And Disposal Information; Troubleshooting - Parkside PSHL 2 A1 Traduction Du Mode D'emploi D'origine

Cleaning and ... / Storage / Environmental instructions ... / Troubleshooting
z Cleaning and Maintenance
Do not use any harsh cleaning agents to
„ z
clean the helmet casing
Never bring the UV filter
„ z
with water.
Clean the product with a soft, dry
„ z
cloth, with a cloth dampened with pure
alcohol or with a cloth dampened with
disinfectant.
z Storage
Keep the device in a dry place and out of
„ z
the reach of children.
z Troubleshooting
Error
The filter does not darken in
a normal way or flickers.
The reaction is slow.
The visibility is poor.
The welding helmet slips.
z Environmental instructions
.
2
into contact
8
The device, accessories and packaging
should be recycled in an environmentally
friendly manner.
Do not throw the auto-darkening welding
helmet into household rubbish, fire or water.
If possible, non-operational equipment should
be recycled. Contact your local retailer for
information.
Cause
The protector does not
darken in a normal way or
flickers.
The arc sensor is not clear.
The welding current is
too low.
The ambient temperature is
too low / high.
The sensitivity is too low.
The protector / the protective
screen is dirty.
The protective film on the
protective screen was not
removed.
The ambient light is not
sufficient.
The wrong darkening shade
has been set.
The headband
5
put on incorrectly.
and disposal information
Don't waste, recycle!
Clean the protector or
replace it.
Clean the arc sensor's
surface.
Set the sensitivity to the
maximum degree.
Only use the welding
helmet in temperatures
between -5 °C and +55 °C.
Set the sensitivity to a
higher setting.
Clean the protector and the
protective screen.
Remove the protective film.
Apply more light to your
work surroundings.
Reset the darkening shade.
has been Put on the headband
again tighter.
Solution
5
GB/IE/NI 13