Parkside PSHL 2 A1 Traduction Du Mode D'emploi D'origine page 12

Initial use
You can adjust the delay setting
„ z
configure whether or not the auto-
darkening feature should be switched
off immediately after stopping welding
work, depending on the type of welding
work. At the lowest setting, auto-darkening
is switched off immediately. Turn the
rotary switch clockwise towards the
highest setting to prolong the time the
auto-darkening feature remains active
after welding work. This feature is very
useful for handling afterglow.
You can use the sensitivity setting
„ z
adjust the light sensitivity of the sensor.
With low incident light, the control can be
adjusted to the highest setting to ensure
that the auto-darkening feature is activat-
ed even for a weak light source. Even
with this additional feature, you can also
adjust the light sensitivity of the sensor to
suit your own personal requirements.
Table for setting the darkening shades
1,5 6 10 15 30 40 60 70 100 125 150 175 200 225 250 300 350 400 450 500 600
SMAW
MAG
TIG /
8
GTAW
MIG
(heavy)
MIG
(light)
PAC
PAW 4 5
SMAW: welding with coated
electrodes
MIG (heavy): MIG welding heavy metals
MIG (light): MIG welding light metals
and alloys
12 GB/IE/NI
to
11
to
12
Arc current (ampere)
8 9
8 9
9
9
10
9
6 7 8
The lowlight sensor switches the LED lamp
„ z
on in dark environments and off in brightly
lit environments. This helps to illuminate
the object being welded in dark working
conditions. The LED lamp can be switched
on and off using the lamp control
the battery charge level is too low, you
can replace the batteries. To do so, slide
the left side of the battery compartment
to the left (see figure A). A low battery
15
charge level is indicated with a red
warning light on the display
10 11
10 11
10 11
10 11
11
10 11 12
9 10 11
TIG / GTAW: welding with inert gases
MAG:
PAC:
PAW:
.
13
12 13
12
12 13
12 13
12 13 14
13
12
welding with metal active
gass
plasma cutting
plasma welding
. If
14
14
13 14
14