Flex L 15-10 150 Notice D'utilisation page 14

466.387_L15-10 150_L21-8 180_L26-6 230.book Seite 14 Montag, 19. März 2018 2:35 14
Instruction manual
– Applying moderate pressure, move the
angle grinder backwards and forwards.
This will prevent, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
WARNING
A special cutting guard must be used for
cutting.
See manufacturer's accessories catalogue
for the appropriate cutting guard.
– Do not press, tilt or oscillate the power tool.
– The angle grinder must always be
operated backwards.
Otherwise, there is a risk of the angle
grinder jumping uncontrollably out of the
groove.
– Adjust the feed to the material which is to
be cut: the harder the material, the slower
the feed.
For further information on the manufac-
turer's products go to www.flex-tools.com.
14
L 15-10 150 / L 21-8 180 / L 26-6 230