Electrical; Power Cord - Dimplex Revillusion RBF24DLX Manuel D'utilisation

Electrical

General
The fireplace is packaged with a
three prong plug installed for plug-in
convenience. Hard wiring the fireplace
is also an option for installation.
WARNING: Do not attempt to wire
your own new outlets or circuits.
To reduce the risk of fire, electric
shock or injury to persons, always
use a licensed electrician.
WARNING: Make sure the circuit
on which the fireplace is to be
installed has the power cut off at
the service panel until installation is
complete.

Power Cord

WARNING: This fireplace is for
use on a 120V circuit and has
a grounding plug that looks like
the plug in Figure 1. Make sure
the plug is connected to an outlet
having the same configuration as
the plug. No adapter should be
used with this product.
Figure 1
10
WARNING: Do not use this fireplace
with an extension cord. Plug the
cord directly into an ap propriate wall
receptacle.
Removing Power Cord for
Hardwire Installation
To remove the power cord:
1.
Locate the power cord on the back
of the fireplace. Remove 2 screws
and slide the electrical box back.
2.
Unscrew the 2 wire connectors.
3.
Cut the green (ground wire) leaving
enough length to reuse the wire.
4.
Replace assembly with the hardwire
cover (included).
www.dimplex.com