Electrical Connection; Connecting An Electric Tool; Changing The Filter - Festool CTL Mini Notice D'utilisation D'origine

- Do not use to extract fl ammable or explosive
liquids (e.g. petrol, thinners). - Risk of explo-
sion!
- Do not use to extract aggressive liquids (e.g.
acids, alkalis, solvents)
- This mobile dust extractor is suitable for extract-
ing paint dust.
- Remove plug from mains socket when not in use
and before maintenance work.
- Do not pull plug out of mains socket by its ca-
ble.
- Protect the cable against heat, oil and sharp
edges.
- Do not leave devices out in the rain.
- Check the plugs and cables regularly and have
them replaced by an expert if damaged.
- Do not lift or carry the devices by their handles
using a crane hook or lifting gear.
- The device may only be used by persons who
have been trained in its use and who are au-
thorised to do so.
- If noxious dusts have been extracted, the vacuum
cleaner and all accessories must be completely
cleaned (inside and outside) by suction and
wiping, before removal from the contaminated
area.
Parts that cannot be completely cleaned are to
be packed for transport in a plastic bag with an
airtight seal.
- For safety reasons, only operate the machine
using a totally earthed socket.
- Always use the machine socket for the purpose
specifi ed in the manual.
3 Appliance preparation and initial opera-
tion
3.1

Electrical connection

The operating voltage shown on the rating
plate must correspond to the voltage of
the mains power supply.
Make sure that the vacuum cleaner is
switched off when you plug the power
cable in.
3.2 On/off switch (1.1)
In position 0 the vacuum cleaner is switched off
and the appliance plug socket (1.3) is dead.
Two modes of operation are possible:
a) Switch position „MAN"
The appliance plug socket is live. Before
turning the switch to the „MAN" position,
ensure that the tool connected to the ap-
pliance plug socket is switched off.
The cleaner motor starts immediately.
b) Switch position „Auto"
The appliance plug socket is live. Before
turning the switch to the „Auto" position,
ensure that the tool connected to the ap-
pliance plug socket is switched off.
The cleaner motor starts only when the tool con-
nected to the appliance plug socket is switched
on.
3.3 Suction force regulator (1.2)
The suction force regulator can be used to vary the
suction capacity. This permits a precise adaptation
to different substances to be picked up.
3.4

Connecting an electric tool

Observe the maximum connected load on the
appliance plug socket (see "Technical Data")!
Connect the electric tool to the appliance plug
socket (1.3).
Make sure that the electric tool is switched
off when plugging it in and unplugging
it.
4 Operation
4.1 Changing the fi lter
During the following procedure, take care not to
raise dust more than is unavoidable.
Wear a P2 breathing protection mask with
health-hazardous dusts!
a) Changing the fi lter bag
Order No.:
CTL MINI 498410, CTL MIDI 498411
- Open locking clips (1.4), remove top section
(1.5),
- Change fi lter bag (2.1)–see print on fi lter bag,
- Replace top section, close locking clips.
Note: A replacement fi lter bag can be stored in
the storage compartment (5.4).
b) Changing the fi lter element
Order No.: 456790
Do not operate machine without a fi lter
element. This may damage the motor.
12