Assembly Instructions - Altrad Belle PRO TROWEL 900 Manuel De L'opérateur

GB
Handle Assembly
1. Secure handle in place using M12 x 90 (x1) and M12 x 75 (x1) bolts. (See Diagram 1) Tighten the bolts to a torque setting of 30Nm.
2. Screw the cable down to it's maximum length so the bolt is at the bottom of the slot. (See diagram 2)
3. Fit the threaded end of the cable through the hole in the yoke arm boss. Secure in place using M8 washer and nut. (See diagram 3)
Tighten the M8 nut until all play has been removed from the yoke arm.
1.
4. Connect the electrical cable for the centrifugal clutch cutout switch, ensuring the coloured connectors match up. Red-red, blue-blue
(See diagram 4) Ensure the electrical cable is routed through the guard ring as shown in diagram 5.
WARNING
4.
Throttle Cable Assembly
1. Remove Air Filter Assembly from the engine (See Diagram 6)
2. Set the Throttle Lever on the handle to the idle position. The lever should be in it's lowest possible position. (See diagram 7)
3. Also set throttle lever on the engine to the idle position. (See diagram 8)
6.
4. Thread the throttle cable through the cable clamp (A) so that the metal area located on the end of the cable is gripped. (See diagram 9)
5. Loosen the screw on the cable clamp (B) and slide the throttle cable through the hole. Re-tighten the screw so that it grips the
cable. (See diagram 9 & 10)
9.

Assembly Instructions

2.
IMPORTANT SAFETY DEVICE - Not connecting the Clutch Cutout Switch could result in serious injury.
7.
(A) (B)
5.
10.
10
3.
8.