Electrical Connection; Short-Circuits; Operating Programs (With Jumpers) - Maico ECA 100 ipro Instructions De Montage Et Mode D'emploi

GB
 Insert cable grommet into housing.
Guide power cable into connection
i
area such that the cable grommet
fits around the cable sheathing
completely and does not penetrate
too far into the connection area.

8.2 Electrical connection

Danger to life from electric
shock
 Switch the mains fuse off.
DANGER
Unit damage in the case of
NOTICE

short-circuits

 Insulate PE conductor and
unneeded cable cores
 Only lay single cable cores in the unit. To
do this, reduce power cable sheathing to a
length of 90 mm. Strip single cable cores to
9 to 10 mm.
 Insert housing [1] into wall
breakthrough/wall sleeve and secure with
two screws. Do not insert the housing such
that it is twisted or crushed. Make sure you
use mounting material which is sized for
the purpose.
 Electrically connect power cable to spring
clip [13] according to connection wiring
diagram [14], also see wiring diagrams in
Chapter 14.
16
ECA 100 ipro standard model units
i
can be operated at two levels with
double switches. Without a double
switch, the fan can either be operated
at performance level 1 or performance
level 2, see switch variants in
Chapter 14.
 Check position of cable grommet. It must
be well sealed.
8.3 Operating programs (with
jumpers)
● For unit models VZC, KVZC, F, KF, B and
KB, there are 4 operating programs:
● Comfort program (supplied in this mode),
night program, economy program and
power program.
 Set the operating program you want with
jumpers J4 and J5.
Comfort program
● Performance level 1 while room is being
used, performance level 2 during overrun
time.
● J4 bridged, J5 bridged
100
90
80
70
60
50
40
30
20
10
0
Adjustable
Switch-controlled
start delay
operating time
92 m³/h
78 m³/h
Adjustable
overrun time
t