Electrical Connection - Maico AKE 100 Notice De Montage Et Mode D'emploi

Danger of short-circuits and
NOTICE
damage to the unit. Water will
penetrate if the power cable is
incorrectly fed into the fan
housing or if the cable
grommet is not fitted
correctly.
Cut off cable grommet cap [9]
such that the cable grommet fits
tightly round the power cable.
Cut a minimum
of 5 mm off the cap (power cable
can bend better and electronics
cover [6] can be positioned
correctly).
Fit cable grommet [9] correctly,
seal on both sides if required.
5. Insert cable grommet [9] into housing.
Feed power cable into the
connection area such that the cable
grommet fits around the cable
sheathing completely and does not
penetrate too far into the connecting
area.
6. Lead sensor connection cable, from the
external climate sensor [12], into the hole
provided ( arrow) in the fan housing [1].
7. Insert housing [1] into wall
breakthrough/wall sleeve and secure with
two screws. Do not insert the housing
such that it is twisted or crushed. Make
sure you use mounting material which is
sized for the purpose.
8. Lay sensor connection cable [12] in the
provided recesses (I, II) and plug it [A] into
the electronic circuit board [7].

8.4 Electrical connection

Danger to life from electric
shock.
DANGER
Switch the mains fuse off.
Risk of damage to unit in the
NOTICE
event of short-circuits.
Insulate PE conductor and
individual cable cores that are not
required.
1. Only lay single cable cores in the unit. To
do this, remove power cable sheathing
over a length of 70mm. Strip single cable
cores to 9 to 10 mm.
2. Electrically connect power cable to spring
clip [13] according to connection wiring
diagram [14], also see wiring diagram in
Chapter 13.
3. Check position of cable grommet [9]. It
must be well sealed.
8. Mounting │ UK
19