Spypoint TINY-3 Manuel D'utilisation page 8

14
COMBINE THE TINY-3/S-TINY-3 TO THE
WIRELESS SYSTEM TINY-W3/S-TINY-W3
Remove the cap and screw the antenna on the side of the
TINY-3/S-TINY-3 camera. The camera can be added to
the wireless system
S-TINY-W3 composed of TINY-W3/
S-TINY-W3 camera and Blackbox-D
controller. Up to 10 cameras can be
combined to a single Blackbox-D
(see Blackbox-D manual for more
TM
details).
PROGRAMMING
Turn on the camera to navigate in the interface by pressing
"" or "" and press "OK" for selection. To modify the
selection, press "" and "" again and press "OK" to
confirm. To return to the previous menu press "".
PHOTO
To take pictures. The "Photo" mode must be selected
by pressing "OK"; the test light in front of the camera
will flash for 60 seconds to allow the operator to walk away
from the camera.
TINY-W3/
TM

TM
TINY-W 2s
Test light
VIDEO
To take videos. The "Video" mode must be selected
by pressing "OK"; the test light in the front of the
camera will flash for 60 seconds to allow the operator to walk
away from the camera.
TEST
To set the camera and the desired distance. When
"Test" mode is selected, no picture or video is
recorded. Walk perpendicularly in front of the camera. When
the camera detects movement, the light winks to indicate that
normally, a photo or video would have been recorded. If the
system does not detect the movement, increase the distance
detection using the "Settings" menu (the option "Sensitivity"
allows the user to set the sensitivity to "High", "Medium" or
"Low"). You can also realign the camera differently. Once
you understand how the device responds to detections, you
can better adjust the direction or the height of the camera
In "Test" mode, it is possible to take a picture by pressing
the "OK" button. The photo is saved and appears in
"View" mode.
15