Spypoint TINY-3 Manuel D'utilisation page 60

8
Solar panel
This model offers the possibility of a connection to a solar
panel SP-12V (sold separately, see «Options») to maintain
the charge of the lithium battery pack. During the installation
of the rechargeable lithium battery pack, slide the switch to
«LIT-09» to activate the charging system of the solar panel.
Power source
• 6AA
• 12V
• 12V + 6AA
• LIT-09
• 12V + LIT-09
• Solar Panel + LIT-09
MEMORY CARD
Using a memory card (sold separately, see "Options") is
required to operate the controller. The controller supports a
32GB memory capacity. Before inserting or removing the
memory card, the controller must be turned off. Failing
to do so may cause loss of pictures or damage the pictures
already recorded on the memory card. When the SD card is
full, the transmission and recording of images continues by
clearing the first photos of the corresponding camera on the
memory card.
Switch position
ALK
LIT-09
"BUSY" LED
The "BUSY" light, located above the LCD screen, lights up
when the controller records a file.
How to properly install your controller
using the supplied installation strap:
(Recommended installation height: about 3 feet).
PROGRAMMING
Turn on the controller to navigate in the interface by
pressing "" or "" and press "OK" for selection. To
modify the selection, press "" and "" again and press
"OK" to confirm. To return to the previous menu press
"BACK".
Note: When the controller is left inactive for more than 2
minutes on the main menu, it automatically resets itself to
"START BLACKBOX " mode. To return to the main screen,
TM
turn off the controller and turn it on again.
9