Roco Lokmaus 2 Manuel page 24

GB
Using the ROCO digtial crane you activate the working function with the 'light' and 'F1' buttons. Im-
portant: At the Lokmaus 2
Most of the locos have one function only – the headlights. Few locomotives have a second
function (e. g. a digitally controlled smoke generator, digital uncoupler, sound etc.) Therefore on
most of the locos the function keys don't control nothing. To operate those additional functions
the loco must be equipped with a special deoder or an additional function decoder. For the
future it is ROCO's plan to raise the playworth of the railroad by adding functions to locos and
cars. So these functions already have been integrated into the Lokmaus 2
24
The knob is to control speed and direction of a loco. set to the middle the speed
of the loco is 00 and the loco stops. Turning it right you make the loco run for-
ward with increasing speed. Turning the knob to the left the loco runs backwards.
Turning it back to the middle makes the loco run slower. The loco reacts with the
programmed acceleration and deceleration delay. If this delay is programmed to
a high value the reaction to the movement of the knob doesn't come immediately
but may take some time. That way the loco decoder simulates the big weight of
a long train.
By the arrow-buttons 'up' and 'down' you select the address of the loco you
want to control. Pressing 'up' for a short time increments the loco address by one.
Pressing this button for a longer time it starts the smart-search-function upwards.
The same you do by preesing the 'down' button but the address is decremented
by one or the smart-search-function is started downwards. The selection of the
loco address gets valid in the moment when you give a command to this loco, e.g.
a speed command or if you switch a function on or off. The point at the right of
the display gets visible permanently. The smart-search-function makes it easy to
re-find a loco address (see below).
â Inside a menu these buttons select the parameter-value.
The button 'stop' causes an emergency stop. All locomotives stop and the feed-
ing of the layout is interrupted. During this emergency stop mode you can select
new loco addresses and give commands to those locos e.g. to stop them or give
new commands so that they don't continue their way after releasing the stop-
mode. Pressing 'STOP' the second time you release the stop mode and the locos
re-start to run. The commands you gave during the stop-mode are executed now
immediately. If a short circuit had happened you release it by pressing 'STOP'.
â Inside a programming menu you quit the menu by pressing 'STOP'.
The programming button 'P' leads you into the programming menu for loco-
motives and switch-decoders and to different setup-menus. With this button you
confirm selected parameters and start the programming procedures.
The star-button switches the headlights on and off. Pressing this button the first
time the headlights start to shine, pressing it the second time it switches the
headlights off. It is important to make sure that the selected speed steps of the
loco decoder and the selected speed steps of the Lokmaus 2
the headlights don't work correctly or the loco doesn't run (see programming of
the CV29 page 27).
The function buttons 'F1' to 'F4' control the additional functions of a loco such
as smoke, digital uncoupler or sound. You also operate the additional functions
of a car equipped with a function decoder e. g. headlights, illumination or signal
horn. Pressing this button the first time it switches on the function, pressing it a
second time it switches off the function.
the address of the digital crane must be set to the 14-speed-steps mode!
®
will match, If not
®
.
®