Good To Know - SOLIS 5510 Mode D'emploi

▲

GOOD TO KNOW

1. Never exceed the MAX marking when filling the kettle as this might cause the
water to splash out of the kettle during boiling and cause scalding resp. electric
shock!
2. Filled to the MAX marking, the kettle holds 1,7 litres of water.
3. Never fill the jug with too little water. The MIN marking (500 ml) has to be rea-
ched every time, otherwise the overheat protection is triggered and the appliance
switches off.
4. Always check if the lid is correctly closed before connecting the power plug to
the socket.
5. Dry the kettle outside as well as the kettle bottom and the appliance base
before plugging in the plug.
6. During heating, you can stop the heating process at any time by pressing the
ON/OFF toggle switch.
7. Should there be too little water in the kettle or should the water have evaporated,
thereby triggering the overheat protection, pull the plug and let the appliance cool
down for 15 minutes before refilling cold water into the kettle.
8. Do not press the lid latch during or shortly after use to open the lid. Hot water
might squirt out of the jug. If you want to open the lid, f.e. to refill cold water,
the hot water remaining in the jug should be poured out through the spout first,
with the lid closed.
9. Because steam has to be allowed to escape from the jug during boiling, the spout
is always open. Therefore, water might escape when the full jug is tipped over
or placed on its side. Consequently, the jug filled with water has to be in an
upright position at all times.
44
All manuals and user guides at all-guides.com