Good To Know - SOLIS 586 Mode D'emploi

GOOD TO KNOW

▲
1. Never exceed the MAX marking when filling the kettle as this might cause the
water to splash out of the kettle during boiling and cause scalding resp. electric
shock!
2. Filled to the MAX marking, the kettle holds 1,5 liters of water.
3. Always check if the lid is correctly closed and locked before connecting the power
plug to the socket.
4. Dry the kettle outside as well as the kettle bottom and the appliance base before
plugging in the plug.
5. Should the temperature difference between the current water temperature in the
kettle and the set temperature be less than 5°C, the appliance can not be reac-
tivated.
6. When the appliance is in operation mode or in standby mode, every touch of
the symbol will decrease the temperature by 10°C, the light at the corres-
ponding temperature lights up blue. 40°C is the lowest temperature that can be
set. Every touch of the
at the corresponding temperature lights up blue. 100°C is the highest temper-
ature that can be set. If the set water temperature is lower than the actual water
temperature in the kettle, the appliance can not be started.
7. The blue light always indicates the set water temperature, the red light indicates
the current water temperature.
8. When the water has reached the set temperature, the light corresponding to the
chosen number lights up red and a single beep can be heard, all other red dots
go out. The appliance ends the heating process and switches to standby mode.
9. During heating, the heating process can be stopped resp. the appliance can be
switched to standby mode at any time by touching the ON/OFF button.
10. If the water temperature is below 40°C or the kettle is not on the appliance base,
no light on the control panel lights up.
11. If there is only a small amount of water in the kettle, the set temperature, espe-
cially in the lower ranges, might be slightly exceeded. This is because the small
amount of water is quickly heated by the powerful heater element. It surpasses
the set temperature, even though the heater element is switched off as quickly
as possible.
12. Because it is necessary for steam being able to escape during boiling, the lid will
not close completely, even when locked into position. Therefore, water can
escape when the full kettle is tilted, placed on the side or even turned upside
down. Consequently, the filled kettle has to be kept in an upright position at all
times.
symbol will increase the temperature by 10°C, the light
4
53