Transport; Useful Information - Honda HRX426C Manuel De L'utilisateur

TRANSPORT

TRANSPORTING THE LAWNMOWER
Do not tilt the lawnmower since this may cause fuel or oil spillage;
spilt fuel or even fuelvapours are a fire hazard.
To transport the lawnmower:
1. Place the throttle lever in
"STOP" position (except PDEH,
SDEH types).
2. Pull off the spark plug cap.
3. Close the fuel shut-off valve [1].
To facilitate the operation:
1. Remove the grass catcher
(see page 4).
2. Loosen the handle
attachment knobs [2], pull out
the adjustment stops [3] and
fold the handle [4].
NOTE: After folding the handle,
check that the cables are not
kinked, twisted or stretched.
LOADING THE LAWNMOWER
CAUTION:
• To prevent losing control of or damaging the lawnmower, do not
use the drive system when going up or down a loading ramp.
• To prevent damaging the drive system, do not engage the clutch
when the lawnmower is rolling backwards.
• Transport the lawnmower in normal horizontal position with its four
wheels flat on the vehicle platform.
• We recommend that you use a loading ramp or that you get
someone to help you load and unload the lawnmower.
• Adjust the loading ramp so that it is inclined at an angle of less
than 15°.
• When transporting the lawnmower, immobilise it using straps and
place chocks under the wheels.
• The straps must not touch the following parts of the lawnmower:
throttle lever, cutting-means control lever, gas tank and all the
control cables.
14 EN
C11 C18
SAFETY
[1]
[3]
[2]
15°max

USEFUL INFORMATION

FIND AN APPROVED DEALER
Please refer to the European Internet site:
http://www.honda-eu.com
[5] [6]
[11]
CURRENT PARTS, OPTIONAL ATTACHMENT
AND CONSUMABLES
To buy one of the original parts listed below, or any other part,
please contact an approved Honda reseller.
HRX426C
Current parts
Grass
[5] 81320-VG8-A51
catcher
[6] Rear wheel 42700-VK8-753
[7] Air filter 17211-Z8B-9010
[8] Front wheel 44700-VK8-000
[9] Spark plug
Standard
[10] cutting 72511-VK7-000
means
[11] Recoil starter 28462-ZL8-V71
Optional part
Mulching kit 06762-VK7-000
[12]
Consumables
08221-888-061HE
[13] Engine oil
SAE 10W30, 0.6 l
For your safety, it is strictly prohibited to
install any other attachment than the ones
listed above and especially designed for
your lawnmowers' model and type.
[7]
[12] [13]
HRX476C
Grass catcher only
81320-VK8-003
(without frame)
Filter paper
NGK (brand) :
98079-55846
BPR5ES (model)
Requires use of a
72511-VK8-000
dynamometric key
Ask your Honda
dealer to replace
these
1 upper cutting means,
06762-VK8-000 1 mulching plug,
1 Owner's Manual
Oil for 4-stroke
engines
SAFETY
[8]
[9]
[10]
A2 C5
C23
D3