After-Sales Service And Application Service; Transport; Disposal - Honda Miimo HRM40 Live Manuel Du Propriétaire

14 | English
Problem
Mower leaves ragged
finish/poor quality
of cut
Perimeter wire not
detected
Height-of-cut button
stuck
After-sales Service and
Application Service
In all correspondence and spare part orders, please
always include the 4+7 digit article number given on the
type plate of the mower .
It is possible, that the software version of your mower is
required (see "Menu > Settings > Info").
If the mower is requested to be returned to the authorised
Honda dealer, the mower and docking station must
always be returned together .
The product must be periodically inspected and
maintained for safety and to keep it running at a high
level of performance .
Periodic maintenance will also help to extend service
life .
Honda recommends annual service to be completed by
your local authorised Honda dealer .

Transport

The contained lithium-ion batteries are subject to
the Dangerous Goods Legislation requirements . The
batteries are suitable for road-transport by the user
without further restrictions .
When shipping through third parties (e .g .: by air
transport or forwarding agency), special requirements
on packaging and labelling must be observed . For
preparation of the item being shipped, consulting an
expert for hazardous material is required .
Possible Cause
The mower does not mow often
enough
Cutting blades blunt
Possible clogging
No power at the docking station
Perimeter wire cut
Wrong installation (e .g . not
enough distance between wires)
Perimeter wire close to a source
of interference
Possible clogging
Corrective Action
Mow more frequently for a good result (e .g . by means
of more/longer slots in schedule).
Reverse or replace cutting blades (see figure K).
Always turn On/Off switch off first, then check
underneath the mower . Clear out as necessary (always
wear protective gloves).
Check if the docking station is powered up (LED is on).
Check perimeter wire for damages .
Follow instructions in the Installation Guide .
Remove any excess (e.g. coiled up) perimeter wire
around the docking station . Change perimeter wire ID
in the menu .
Always turn isolator On/Off off first, then check
underneath the mower . Clear out as necessary (always
wear protective gloves).

Disposal

The garden product, batteries, accessories and
packaging should be sorted for environmental-
friendly recycling .
Do not dispose of garden products and
batteries/rechargeable batteries into household
waste!
Only for United Kingdom:
According to Waste Electrical and Electronic Equipment
Regulations 2013 (SI 2013 No. 3113) and the Waste
Batteries and Accumulators Regulations 2009
(SI 2009 No. 890), power tools that are no longer
usable must be collected separately and disposed
of in an environmentally friendly manner .
Only for EC countries:
According to the European law 2012/19/EU, electrical
and electronic equipments that are no longer usable, and
according to the European law 2006/66/EC, defective or
used battery packs/batteries, must be collected separately
and disposed of in an environmentally correct manner .
Battery packs/batteries:
Li-Ion:
Please observe the instructions under Transport .