Inserting The Sensor Into The Fitting - Burkert 8020 Manuel D'instructions

2.2 INSERTINg THE SENSOR INTO THE FITTINg

The 8020 flowmeter can be installed in any pipe using our specially designed S020 fitting
system.
The sensor can be installed whatever the inclination of the pipe.
When mounting fitting , make sure to respect the instructions described in § 2.1
and within the instruction manual of the fitting. Then:
- Insert nut  into fitting  and let plastic ring 2 snap into guide bush .
- Carefully insert the sensor into the fitting. If installed properly, the
sensor cannot be rotated.
- Tighten the sensor to the fitting using nut .
Only tighten the nut by hand!
INSTALLATION
1
2
3
4
5

8020