Selve SE Plus Notice page 28

GB Setting of the end positions
4.5.1. Semi-automatic setup-mode, deletion and semi-automatic setting of the
end positions
in operation bottom position, top stop/release
When the movement is interrupted twice during operation, the system is in semi-
automatic setup-mode. The drive will only find the upper end limit automatically.
Important: A limit stop for the upper end limit is necessary!
First the lower end limit has to be run-up to. From there move against the upper limit
stop without interruption, until the motor is automatically switched off.
Operation Operation with
with switch setting switch
1 s
E
E
or
Drive
Press the E button of the setting switch for
1 second. Both limit positions already set will be
deleted.
Note: Not required for the initial installation or after
resetting to factory defaults.
Move the motor with the UP or DOWN button
downwards to the requested lower end limit.
Run against the limit stop at the top without stop-
ping; the motor stops automatically. The correct
direction of rotation assignment has been made.
Perform a test run: The drive moves up against the
limit stop and relieves shortly.
28