How To Clean The Rice Cooker - Tiger JBV-A10U Mode D'emploi

9
How to clean the rice
cooker
Clean the rice cooker following the steps shown on pages 23 and 24.
Any other servicing should be performed by an authorized service representative.
Wash all parts by hand. Do not use a dish washer to wash parts.
We recommend that you clean the rice cooker within the day you use it. This can help
extend the life of your rice cooker. It is also recommended that you clean the rice
cooker periodically.
z When using the slow cook function, because odors can easily linger, be sure to clean
the cooker within the day of use. (Refer to page 24)
Guidance
Before cleaning, remove the plug and wait until the cooker has cooled down.
Use kitchen detergent (for dishes and kitchen tools) to wash parts.
Choose a sponge or cloth made of soft materials for cleaning.
Parts to wash after every use
Inner pan
Measuring cup
Cooking plate
Parts to clean whenever they become dirty
Heat releasing
plate
Upper
casing
Hook
button
Rice paddle
Pressure control cap
Outer lid
gasket
Power cord
Insert plug
Center
sensor
1. Clean with a sponge and water, or with lukewarm water.
2. Wipe water away with a dry cloth, and dry the parts completely.
C a u t i o n
z Do not use the polishing
part of the sponge to clean
the inner pan. Doing so may
cause the fluorine coating of
the inner pan to peel.
z Do not put dishes into the
inner pan and use it as a
dishpan. When drying the
inner pan, do not put it over
dishes or pile it together with
dishes. Doing so may cause
the fluorine coating of the inner pan to peel.
z Wipe the inside and outside of the main body with a tightly
wrung-out squeezed cloth to make it clean.
z Wipe the power cord with a dry cloth.
z Remove rice or grain which is stuck on the upper casing or
hook button.
z Remove rice or grain which is burned and stuck on the
heater plate or center sensor.
* If it cannot be removed easily, use materials such as store-
bought sandpaper (No. 320 may be suitable), and then wipe
parts with a tightly wrung-out cloth.
C a u t i o n
z Make sure that there is no water entering inside the
main body.
z Do not soak the power cord in water or splash it
with water. Doing so may result in short-circuiting,
electric shock, or malfunction.
z Do not pull the gasket which is attached to the lid.
Do not use
the polishing
part.
23