Kuhn Rikon DUROMATIC Mode D'emploi page 90

11.1.3 Dismantling the TIMAX valve
To dismantle this valve, undo the valve screw (2) on the lid inside
using a coin or screwdriver (Diag. 11A).
11A
11.1.4 Dismantling the Top valve
To dismantle this valve, undo the valve screw with integral pressure indicator (2)
on the lid indside using a screwdriver (Diag. 11B).
11B
11.1.5 Cleaning and re-assembling the valve
1. Disassemble the valve and clean it. Never use any abrasive cleaners.
2. During re-assembly, ensure that the valve cap is securely fastened to
the pressure indicator stem and that the valve screw has been fully
tightened by hand.
3. Check for proper valve operation after assembly. (See section 6)
82
1 Counter nut
2 Valve screw
3 Pressure indicator
4 Valve spring
5 Valve seal
6 Valve socket
1 Counter nut
2 Pressure indicator
3 Valve spring
4 Valve seal
5 Valve socket
6 Valve cap with
integral pressure
indicator