Accessories And Spare Parts - 3M Peltor Lite-Com Pro II Mode D'emploi

EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011, EN 60079-0:2009, EN 60079-11:2007, EN 61241-11:2006
The product has been examined by :
Combitech AB, Kungsörsvägen 68, SE-732 81 Arboga, Sweden, Notified body #2279
BACL, Bay Area Compliance Laboratories Corp. Shenzen,Guangdong, China, Notified Body #0313
NEMKO, Gaustadalléen 30 N-0373 OSLO, NORWAY Notified Body #0470
– WARNING – SPECIAL CONDITIONS FOR SAFE USE:
Substitution of components may impair intrinsic safety.
Equipment with broken or otherwise damaged enclosure shall not be operated in the hazardous locations.
Use only 3M™ Peltor™ ACK08 battery.
Change batteries only in locations known to be non hazardous!
Charge only with specified charger cable (3M™ Peltor™ AL2AH)!
ATTENUATION
The attenuation values for each model are found in Fig. E.
The rows in the figure describes:
E:4 Frequency, the frequency value at which the attenuation testing has been done.
E:5 Mean attenuation (dB) = Average attenuating characteristics at given frequency
E:6 St. dev. (dB) = Standard deviation at given frequency
E:7 APV (dB) = Assumed Protection Value. Average attenuating characteristics minus standard deviation at given frequency.
Under Fig E:8 the H, M and L values, as well as the SNR are found.
H = Average attenuation characteristics in the higher frquency spectrum
M = Average attenuation characteristics in the mid range frequency spectrum
L = Average attenuation characteristics in the higher frequency spectrum
SNR = Single Number Rating
SAFETY HELMET COMBINATIONS
Appendix A is a list of safety helmets approved for use with MT*H7P3*.
1. Helmet attachment list for MT*H7P3*.
2. Safety helmet, manufacturer and model
3. Attachment (3M™ Peltor™ P3*)
4. Headform size: S=small, N=medium, L=large

ACCESSORIES AND SPARE PARTS

Contact your Authorised 3M™ Peltor™ Lite-Com Pro II dealer!
Notice!
When using and repairing I.S. -approved equipment, all instructions and regulations must
be followed to the letter!
3M™ Peltor™ HY79
Easy to replace hygiene kit consisting of two foam pads, two foam rings and snap-in ear cushions.
Replace at least twice a year to ensure constant attenuation, hygiene and comfort! (Fig. P)
3M™ Peltor™ HY100A
A single-use protector that is easy to apply to the ear cushions. Package of 100 pairs.
3M™ Peltor™ HYM1000
Moisture and wind-tight and hygienic tape. Protects the speech microphone and enhances its life span.
Package of 5 metres for about 50 replacements. (One metre sample is included on delivery.) (Fig. R)
3M™ Peltor™ M995
Effective protection from wind noise. Enhances the life span and protects the speech microphone.
One per package.
3M™ Peltor™ M40/1
Effective protection from wind noise. Enhances the life span and protects the speech microphone.
Hygiene kit
Clean – single-use protectors
Mike Protector
Wind shield for MT53-type speech microphones
Wind shield for MT7-type speech microphones
7