Puky Ceety Mode D'emploi page 22

T Pull the two parts with the red locking up
and out and place all three parts of the seat
belt on the outside so that they cannot
become trapped while mounting the seat
T Look from above through the holes in the
seat in order to find the correct position for
the screw connection. Move the seat a little
to establish the position where the holes in
the seat are exactly in line with the nuts in
T Place the prepared seat moulding with
padding in the seat and press down firmly to
ensure it is in the correct position.
T
and the seat with one hand and fit the first
screw through the slot in the padding into
T
8 Nm). Exert a little pressure on the screw
in order to feel the screw engaging in the
thread.
T Now fit the second screw and tighten it
T Arrange the three parts of the seat belt,
making sure that the belts are not twisted,
Mounting Backrest
T
the two hinge pins in the opening on the
T
side of the backrest against the seat until
the other hinge pin snaps into the opening
in the seat and the backrest moves
smoothly forward and back.
Securing Seat Belt
T Place the backrest in an upright position.
T Remove the two clips from the loops at the
ends of the belt.
T Make sure that the loops of the padding lie
under the belts and, working from the front,
pass the belts and padding loops one after
the other through the two upper or lower
slots in the backrest padding, depending on
T Then pass the belts and padding loops one
after the other through the slots on the same
T Pull the belts and padding loops right
through the slots.
20