Puky Ceety Mode D'emploi page 21

Mounting Handlebar
T
logo on the protective padding faces forward
T Slide the handlebar from above on to the
handlebar stem and firmly press down as
far as it will go.
T
T Then slide the protective cap back over the
Fitting Push-Bar
T
engages in one of the three holes on the
T Release the red lever on the frame under
the seat mount and hold it in the up position
T
on the lower end points backwards
T
recess in the holder and snaps in below the
lever.
T
bar.
User Manual
The carrier net is already fixed to the storage
tray.
T
the storage tray over the rear axle and
T
axle to snap it on to the rear axle.
T Lock the storage tray in position by pressing
down the rear section so that the latch
snaps into the hook under the seat mount
the hook a little with the other hand.
T Attach the two loops of the carrier net to the
Mounting Seat
The seat moulding is already integrated and
fixed in the seat padding.
T Remove the two screws from the seat
mount on the frame.
T Place the seat on the seat mount.
T
press the bottom end of the buckle with one
19
GB