ASSEMBLY STEp 2
HARdWARE bAG 2 CONTENTS :
BOLT (B)
SPRING WASHER (C)
15 mm
15 mm
Qty: 8
Qty: 8
CONSOLE CABLE
(THREAD THROUGH
TOP OF CONSOLE MAST)
RIGHT CONSOLE MAST
CONSOLE MAST
SUPPORT TUBE
ARC WASHER (E)
SPRING WASHER (C)
BOLT (B)
FLAT WASHER (D)
SPRING WASHER (C)
BOLT (B)
FLAT WASHER (D)
ARC WASHER (E)
15 mm
17 mm
Qty: 4
Qty: 4
Open hardware bag 2.
A
Slide the left console mast
B
down onto the console mast
support tube. Bolt in place
using 2 bolts (b), 2 spring
washers (c), and 2 flat
washers (d) on the side. Then,
bolt in place using 2 bolts (b), 2
spring washers (c), and 2 arc
washers (e) on the front.
Repeat on the other side.
C
On right console mast, the
console cable must be threaded
through the mast.
NOTE: Do not completely tighten any
step 4
screws or bolts until
NOTE: Be careful not to pinch any wires
while assembling the masts.
is complete!
11