Troubleshooting - Zephyr Okeanito COK-E36CSX Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM
Possible Problem
After installation, the
unit doesn't work.
Light works, but
blower is not turning.
The unit is vibrating.
The unit is whistling.
The blower is working,
but the lights are not.
Okeanito Use, Care, and Installation Guide
Possible Cause
The power source is not turned
ON.
The power line and the cable
locking connector is not
connecting properly.
The switch board and control
board wirings are disconnected.
The switch board or control board
is defective.
Wire harness from external
or internal blower might be
disconnected.
The thermally protected system
detects if the blower is too hot
to operate and shuts the blower
down.
Damaged capacitor.
Blower molex plug pin is not
making contact.
The blower is defective, possibly
seized.
The blower is not secured in place. Tighten the blower in place.
Damaged blower wheel.
The hood is not secured in place.
A filter is not in the correct
position.
The duct pipe connections are not
sealed or connected properly.
The LED light connector is
disconnected.
Defective LED light.

Troubleshooting

Solutions
Make sure the circuit breaker and the
unit's power is ON.
Check the power connection with the
unit is connected properly.
Make sure the wirings between the
switch board and control board are
connected properly.
Change the switch board or control
board.
Make sure the wires are connected to
the control board box.
The blower will function properly after
the thermally protected system cool
down.
Change the capacitor.
Disconnect the blower molex plug, check
pins inside plug to see if pin is pushed
inside the plug too far. Reset pin if
needed.
Change the blower.
Replace the blower.
Check the installation of the hood.
Adjust the filters until the whistling stops.
Check the duct pipe connections to be
sure all connections are sealed properly.
Connect the LED light connector.
Change the LED light.
23