Managing Users; Adding Users With An Associated Command - Motostar SLS24 Manuel D'installation

MANAGING USERS

 When adding/deleting users, the fl ashing numbers that appear, are numbers that can be used for other users you may wish to
add (maximum 25 users).
 Before registering the users, make sure that the RXStar radio board is fi tted into the connector (see paragraph titled CONTROL
DEVICES).

Adding users with an associated command

Select U1.
Press ENTER to confi rm.
Select a command to associate to the user.
The commands are:
- 1 = step-step (open-close);
- 2 = sequential (open-stop-close-stop);
- 3 = open;
- 4 = partial opening/pedestrian;
- 5 = do not use.
Press ENTER to confi rm...
... a number from 1 to 25 will fl ash for a few seconds
Send the code from the transmitter or from any other control
device, such as a keypad selector.
Associate the number to the added user.
 If you want to add another command on the same
transmitter, repeat the procedure and associated it on
another button.
User
U i
1 -
2 -
3 -
4 -
5 -
6 -
2
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14 -
15 -
16 -
17 -
2 5
18 -
19 -
20 -
21 -
22 -
23 -
24 -
25 -
Associated command