Motostar SLS24 Manuel D'installation page 33

F46 Number of motors
For setting the number of motors connected to the control panel.
F50
Do not modify. Function unavailable.
F51
Do not modify. Function unavailable.
U 1 Entering a user
Entering up to up to a 25 users maximum and associating to each one a function chosen among the existing ones. This must be done via
transmitter or other control device (see "ENTERING USERS WITH ASSOCIATED COMMAND paragraph).
U 2 Deleting a user
Deleting a single user
U 3 Deleting users
Deleting all users.
A1 Type of motor
Select 5 to confi gure the control board for the gearmotors.
A2 Motors test
Test for checking the gearmotors' proper rotating directions (see the MOTORS TEST paragraph).
A3 Self-learning of gate travel
Automatic self-learning of the gate travel (see paragraph on SELF-LEARNING OF THE GATE TRAVEL).
 This function appears only is the Encoder function is activated.
A 4 Resetting parameters
Warning! The default settings are restored and self-learning of the gate travel is cancelled.
H1 Version
View the fi rmware version.
0=M1 e M2 (default) / 1=M2
0= Deactivated (default)
0= Deactivated (default)
1= Step-step command (open-close) / 2= Sequential command (open-stop-close-stop)
/ 3= Open only command / 4= Pedestrian/ partial / command 5= Do not use
0= Deactivated / 1= Deleting all users
1= (default) / 2= do not use / 3= do not use / 4= do not use / 5=SLS24 / 6= do
not use / 7= do not use
0= Deactivated / 1= Activated
0= Deactivated / 1= Activated
0= Deactivated / 1= Activated