Signaling Devices - Motostar SLS24 Manuel D'installation

Photocells (safety test)
At each opening and closing command, the control board checks
the efficacy of the safety devices (such as, photocells).
Any malfunction will inhibit any command and Er4 will appear on the
display.
For this type of connection, enable function F5.

Signaling devices

Output for connecting the flashing signal light.
(Contact rated for: 24 V AC (normally) - 25 W max).
If the power is out, you can power up the 24 V DC

accessories by using buffer batteries.
R X R X
10 2 TX C NC
10 11 E TS 1 2 3 3P 4 5 7 CX CY
10 11 E TS 1 2 3 3P 4 5 7 CX CY
T X T X
TX 2