General Warnings - Motostar SLS24 Manuel D'installation

Masquer les pouces Voir aussi pour SLS24:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47

GENERAL WARNINGS

Follow all instructions. Improper installation may lead to serious
bodily injuries. Before continuing, alsoread the precautions in the
This product must only be used for its specifi cally intended
purpose. Any other use is dangerous. LABEL HABITAT SAS
is not liable for any damage caused by improper, wrongful
or unreasonable use of this product. • This manual's
product is defi ned by machinery directive 2006/42/CE as
"partly-completed machinery". Quasi-completed machinery
is a set that almost constitutes a machine, but which,
alone, cannot ensure a clearly defi ned application. Partly-
completed machinery is only destined to be incorporated or
assembled to other machinery or other partly-completed
machinery or apparatuses to build machinery that is
regulated by Directive 2006/42/CE. The fi nal installation
must be compliant with European directive 2006/42/CE and
European reference standards:
EN 13241-1, EN 12453, EN 12445 and EN 12635.
Given these considerations, all procedures stated in
this manual must be exclusively performed by expert,
qualifi ed staff.• The operator cannot be used with gates
fi tted with pedestrian doors, unless its operation can
be activated only when the pedestrian door is in safety
CAUTION: Important safety instructions.
operating and maintenance manual.
position • Make sure that people are not entrapped
between the gate's moving and fi xed parts due to the
gate's movement • Before installing the operator, check
that the gate is in proper mechanical conditions, that it
is properly balanced and that it properly closes: if any of
these conditions are not met, do not continue before having
met all safety requirements • Make sure that opening and
closing limiters are fi tted • Make sure the operator is
installed onto a sturdy surface that is protected from any
impacting shocks • Make sure that mechanical stops are
already installed • If the operator is installed lower than
2.5 from the ground or from any other access level, fi t any
protections and signs to prevent hazardous situations •
Do not fi t the operator upside down or onto elements that
could yield to its weight If necessary, add reinforcements
to the fastening points • Do not install door or gate leaves
on tilted surfaces • Check that no lawn watering devices
spray the operator with water from the bottom up •
Suitably section off and demarcate the entire installation
site to prevent unauthorized persons from entering the

Publicité

Table des Matières
loading

Table des Matières