Dynamic Weighing - Mettler Toledo AL Mode D'emploi

Functions
18
101. 6 0
150. 8 8 g
" " " " "
101. 6 0
" " "
" "

5.3 Dynamic weighing

Dynamic weighing is suitable for the weighing of unstable weighing samples. The mean value of the weighing results is
determined over a specified time period (weighing time). The more unstable the weighing sample, the longer the selected weighing
time.
Requirement
"F dYn A" for automatic start or "F dYn M" for manual start must be activated in the menu (Section 4). Factory setting is a
weighing time of 3 seconds (t = 3").
0. 0 0 g
" " " " "
á
0. 0 0 g
á
• 257. 3 5 g
▼
á
-- 3 --
á
-- 1 --
▼
á
260. 3 3 g
*
Switching between percent weighing and weight display
%
➞ Place weighing sample in centre of pan.
The weight of the sample is displayed as a percentage of the target weight.
➞ Press the «"
again, in unit 2, provided this function is activated).
%
➞ Return to display in percent: pressing the «"
Dynamic weighing with automatic start (F dYn A)
➞ The «"
" » key can be used select the dynamic weighing. The display shows the
" "
"
symbol á.
➞ Load weighing sample. As soon as the balance is relatively stable, weighing
starts automatically.
During the weighing time, a "count down" runs in the display.
➞ Read off result.
The result of the dynamic weighing is displayed with ✱ (= calculated value) and
remains in the display until the weighing sample is removed from the weighing
pan or the container.
" » key. The weight is displayed (in unit 1, and if the key is pressed
" "
"
" » key again.
" " "