Preparation By The Purchaser - Nuova Simonelli Oscar Mood Manuel D'instructions

Table des Matières

Publicité

INFORMATION TO THE USERS
the suitable separate waste collection centres of electronic and electro-technical
wastes, or to give it back to the seller or dealer when buying a new equipment of
equivalent type, in terms of one to one.
The suitable separate waste collection for the following sending of the disused
equipment to recycling, the dealing or handling and compatible environment dis-
posal contributes to avoid possible negative effects on the environment and on the
people's health and helps the recycling of the materials the machine is composed
of. The user's illegal disposal of the product implies the application of administrative
fines as stated in Law Decree n.22/1997" (article 50 and followings of the Law Decree
n.22/1997).

PREPARATION BY THE PURCHASER

Preparation of the installation site.
The purchaser must prepare the surface on which the machine will stand suitable
to support the machine weight (see the installation chapter).
Electrical requirements.
The mains power installation must comply with the safely regulations and stand-
ards in force in the country of installation and must include an efficient earth sys-
tem. An omnipolar cut-off device must be installed on the power line upstream of
the machine.
The power wires must be sized according to the maximum current re-
quired by the machine to ensure a total voltage loss under full load of
less than 2%.
Plumbing requirements.
Prepare a suitable drain and a mains that supply water a maximum hardness of 3/5
French degrees (60/85 ppm).
Under the senses of the Directives 2015/863/EU con-
cerning the reduction of the use of dangerous sub-
stances in electric and electronic equipment, as well as
the disposal of wastes.
The symbol of the crossed large rubbish container that
is present on the machine points out that the product
at the end of its life cycle must be collected separate-
ly from the other wastes. The user for this reason will
have to give the equipment that got to its life cycle to
15

Publicité

Table des Matières
loading

Table des Matières