Valor HeatShift LDK1 Directives D'installation page 15

Remove Convection Baffl e (EXCEPT LX2
2200J—go to Installation section next page)
To be eff ective the LDK Duct Kit requires that a
convection baffl e located above the fi rebox inside the
appliance case be removed to allow the hot airfl ow to
convect upwards into ducts installed on the fi replace.
Take-off Convective
airfl ow with
collar
baffl e removed
Convection
baffl e to be
removed
Convective
airfl ow with
baffl e in place
Re-direction of convected air after removing baffl e
!
Remove the convection baffl e from the
appliance. It is held in place by screws located
right behind the upper edge of the fi replace
opening (3 screws/baffl e, 4 for 1400J's baff fl e).
Recycle this panel as it is no longer needed.
Note: The 1600J has two convection baffl es
to remove, one on each side.
Appliance front panel—shown transparent for clarity
C o
n v
e c
t i o
n b
a ffl
Remove convection baffl e—
1500J, 1700J 1800J
WARNING
!
DO NOT INSTALL 1270RBK Remote
Blower Kit to any of these 4 takeoff s.
Firebox
e
Appliance front
panel—shown
transparent for clarity
C o
n v
e c
t i o
n b
a ffl
e
Remove 2 convection baffl es,
one on each side—1600J
Appliance top panel—shown transparent for clarity
C o
n v
e c
t i o
Remove convection baffl e—
1100J, 1150J or 1400J
C o
n v
e c
t i o
n b
a ffl
e
n b
a ffl
e
13