Stage Selection By Reverse Polarity (Tar) - All Dc Versions (Except Option -Ssm) - Pfannenberg PA 10 Mode D'emploi

en Operating instructions PA 10/ 20 PA X 10-10/..-15 / PA X 20-10/ ..-15
7.1.3 Stage selection by reverse polarity (TAR) - all DC versions (except option –SSM)
Note: Only applicable to DC version!
Not applicable to –SSM versions!
The control inputs C1 and C2 must not be connected on the connection board!
Switch setting should be as follows:
 Switch S2: without reverse polarity protection
 Switch S1 to „+"
Tone "C1+C2" can also be selected by reversing the polarity of the operating voltage to the basic tone (♪):
8. Option
–SSM (soft-start module, only 24V DC)
The inrush current peak is limited to:
PA 10-SSM:
PA 20-SSM:
PA X 10-xx-SSM:
PA X 20-xx-SSM:
The operating voltage is only switched through to the operating equipment from >7 V.
Operating voltage range: 18 V – 30 V DC
Positioning of the resistor (1kOhm) is as follows:
 Always mount the resistor for line monitoring in the last device.
 See below for the position of the second resistor if the sounder and flashing light are connected separately.
 Remove any resistors that are not required.
Common connection of sounder and flashing light:
Separate connection of sounder and flashing light:
01/2021
Base tone
: max. 2.1 A
: max. 4.5 A
: max. 2.1 A
: max. 4.5 A
S2
(on the driver board)
: max. 4.5 A
: max. 4.5 A
Page 12 / 13
S1
Tone "C1+C2"
086200001b