Stage Selection By Reverse Polarity (Tar) - All Dc Versions - Pfannenberg PA L 5 Mode D'emploi

en
7.1.3

Stage selection by reverse polarity (TAR) - all DC versions

Note: Only applicable to DC version!
The control inputs C1 and C2 must not be connected on the connection board!
Switch setting should be as follows:
➢ S1A to
(diode bridged)
➢ and changeover switch S1B to "+"
Tone "C1+C2" can also be selected by reversing the polarity of the operating voltage to the basic tone (♪):
01/2022
Base tone
Page 9 / 11
Operating instructions PA L 5
(on the driver board)
Tone "C1+C2"
086200018c