AEG IAE84881FB Notice D'utilisation page 9

Symbol
5
-
6
7 -
8
9
10
11
12 0 - 9
13
14
/
4.3 Food Sensor
1 2 3 4
The Food Sensor is a wireless temperature
probe operating without a battery, delivered
in a packaging with the hob. Inside its handle
there is an antenna. Another antenna is
located below the hob surface, in the area
between the two rear cooking zones. To
ensure proper communication between the
Food Sensor and the hob do not put anything
on the hob in this area.
The measurement point is located halfway
between the tip and the minimum level mark.
Insert the Food Sensor in the food at least up
to the minimum level mark. For liquids, to get
the best cooking results, immerse the Food
Sensor in the liquid 2-5 cm above the
minimum level mark. Place the Food Sensor
Comment
Zone indicator
-
Slider
PowerBoost
Lock
-
Pause
-
Bridge
Signal indicators
5 6
To show for which zone the slider is active.
To set the timer functions.
To adjust the heat setting.
To activate the function.
To activate and deactivate the function.
The window of the Hob²Hood infrared signal communicator. Do
not cover it.
To activate and deactivate the function.
To show the current heat setting.
To activate and deactivate the function.
Full connection / No signal. To show the signal strength of the
connection between the Food Sensor and the antenna.
Measurement point
1
Minimum level mark
2
Recommended immersion range (for
3
liquids)
Calibration code
4
Hook for placing the Food Sensor on the
5
rim
Handle with antenna inside
6
on the rim of the pot or pan by the hook;
close to the area with the antenna, at 1 - 3
o'clock position (for the left side of the hob) or
9 - 11 o'clock position (for the right side of the
hob).
The following indicators show the strength of
the connection between the hob and the
Food Sensor on the display: , , . If
ENGLISH 9