Ignition And Start Up; Modes Of Operation - Norcold NX64 Manuel D'installation

Ignition and Start Up

Before ignition or start up of the refrigerator:
- Make sure the air flow in the lower intake vent, through the refrigerator coils and condenser, and out the upper exhaust vent is not
blocked or decreased.
- Make sure there are no combustible materials in or around the refrigerator.
Ignition and start up:
If
the gas does not ignite within 30 seconds, the gas valve of the refrigerator will automatically close, the igniter will stop
NOTICE
sparking, an audible alarm will sound, and the fault codes "no" "FL" will flash on the LCD [280]. To reset the controls,
press and hold the POWER ON/OFF button [30] for 1 second to turn the refrigerator off and then press it again to
restart the refrigerator (See Art02397).
If the gas does not ignite after several attempts, refer to the "Fault Codes" section of this manual.

Modes of Operation:

1. Push and release the POWER ON/OFF button [30].
2. Select the mode of operation.
- Push and hold the MODE button [31] to scroll through the available operation modes of the refrigerator, one after the other.
- When the desired mode indicator comes on in the LCD, release the MODE button.
- Or push and release the MODE button again and again to change the available operation modes of the refrigerator, one at a time.
- As you change the mode, the applicable mode indicator will come on.
- On 2-way models, the mode indicators are (See Art02398):
- Auto mode AC electric [281]
- Auto mode gas [282]
- Manual mode AC electric [283]
- Manual mode gas [284]
30 31
281 282
278
280
32
NORCOLD
Art02397
283
284
Art02398
Installation Manual 19