Puky KINDERFAHRRAD Mode D'emploi page 16

SETTING AHEAD STEM
16'' – 18''
The handlebar has been set at the factory to the highest position, thus,
all spacers are located under the stem. If required, remove the stem and
adjust the spacers to lower the handlebar height.
For adjusting the handlebar height for models with ahead stem you will
need the following tools.
(The tools are not part of the scope of delivery.)
• 5 mm and 4 mm Allen key (CYKE und LS-PRO models)
1
1. First undo and remove the ahead cap (5mm
Allen key).
2. Then undo the two steerer tube clamping screws
(4mm Allen key ).
3. Now the stem can be removed from the steerer
ASSEMBLY AHEAD STEM
16'' – 18''
To assemble the ahead stem you will need the
following tools.
(The tools are not part of the scope of delivery.)
• 5 mm and 4 mm Allen key
(CYKE und LS-PRO models)
1. After rearranging the spacers, fit the ahead cap
again, align the handlebars to be straight in the
direction of travel and set the play of the control
bearing correctly. To do this, use the setting screw in
the ahead cap
16
43836_kinderfahrrad_148x210.indd 16 43836_kinderfahrrad_148x210.indd 16
2
2
tube. Now set the handlebar height according to
requirement. Possible positions are:
• All spacers located under the stem (highest handle-
bar position, set at the factory)
• Spacers over the stem and under
1
Correct setting: The handlebars must be easy to turn
without play in the control bearing.
3
(medium handlebar position)
• All spacers above the stem
(lowest handlebar position)
No spacers may be removed!
2
2. Now tighten up the steerer tube clamping screws
of the stem with the correct torque.
The torque for the clamping of the stem on the steerer
tube shaft: 5-6 Nm. Make sure that the stem is firmly
mounted to the steerer tube and cannot rotate.
09.06.2020 07:50:27 09.06.2020 07:50:27
2
GB