Safety Instructions; System Components - Xylem Aquavar 1151AB2 Manuel D'installation Et D'utilisation

1: SAFETY INSTRUCTIONS

1: SAFETY INSTRUCTIONS
TO AVOID SERIOUS OR FATAL PERSONAL INJURY
OR MAJOR PROPERTY DAMAGE, READ AND
FOLLOW ALL SAFETY INSTRUCTIONS IN MANUAL
AND ON EQUIPMENT.
THIS MANUAL IS INTENDED TO ASSIST IN THE
INSTALLATION AND OPERATION OF THIS UNIT
AND MUST BE KEPT WITH THE UNIT.
This is a SAFETY ALERT SYMBOL.
When you see this symbol on the
pump, the controller or in the manual,
look for one of the following signal
words and be alert to the potential for
personal injury or property damage.
Indicates an imminently hazardous situ-
DANGER
ation which, if not avoided, will result in
death or serious injury.
Indicates a potentially hazardous situa-
WARNING
tion which, if not avoided, could result
in death or serious injury.
Indicates a potentially hazardous situa-
CAUTION
tion which, if not avoided, may result in
minor or moderate injury.
Used without a safety alert symbol indi-
CAUTION
cates a potentially hazardous situation
which, if not avoided, could result in
property damage.
NOTE: INDICATES SPECIAL
INSTRUCTIONS WHICH ARE
VERY IMPORTANT AND MUST BE
FOLLOWED.
THOROUGHLY REVIEW ALL INSTRUCTIONS
AND WARNINGS PRIOR TO PERFORMING ANY
WORK ON THIS CONTROLLER.
MAINTAIN ALL SAFETY DECALS.
ALL OPERATING INSTRUCTIONS MUST BE
READ, UNDERSTOOD, AND FOLLOWED BY
THE OPERATING PERSONNEL. CENTRIPRO
ACCEPTS NO LIABILITY FOR DAMAGES OR
OPERATING DISORDERS WHICH ARE THE RESULT
OF NON-COMPLIANCE WITH THE OPERATING
INSTRUCTIONS.
1. This manual is intended to assist in the installation,
operation and repair of the system and must be kept
with the system.
2. Installation and maintenance MUST be performed by
properly trained and qualified personnel.
3. Review all instructions and warnings prior to perform-
ing any work on the system.
4. Any safety decals MUST be left on the controller and
pump.
5. The system MUST be disconnected from
DANGER
the main power supply before attempt-
Hazardous
voltage ing any operation or maintenance on
the electrical or mechanical part of the system. Failure
to disconnect electrical power before attempting any
operation or maintenance can result in electrical shock,
burns or death.
6. When in operation, the motor and pump
CAUTION
could start unexpectedly and cause
Hazardous
Pressure serious injury.

2: SYSTEM COMPONENTS

2: SYSTEM COMPONENTS
Please review the Aquavar AB2 components and insure
that you have all the parts and are familiar with their
names. Be sure to inspect all components Xylem supplies
for shipping damage.
Aquavar AB2:
1. Pump with Motor
2. Aquavar AB2 Controller with Integral Pressure
Sensor Cable
3. Pressure Tank (supplied on some models)
4. Pressure Sensor
5. Mounting Kit
6. Tank Tee with Pipe Plug
7. Pressure Gauge
WARNING
DO NOT power the unit or run the pump
WARNING
until all electrical and plumbing con-
Hazardous
nections, especially the pressure sensor
voltage
connection, are completed. The pump
CAUTION
should not be run dry. All electrical work
Hazardous
must be performed by a qualified techni-
Pressure
cian. Always follow the National Electrical
Code (NEC), or the Canadian Electrical Code (CEC) as
well as all local, state and provincial codes. Code ques-
tions should be directed to your local electrical inspec-
tor. Failure to follow electrical codes and OSHA safety
standards may result in personal injury or equipment
damage. Failure to follow manufacturer's installation
instructions may result in electrical shock, fire hazard,
personal injury, death, damage to equipment, unsat-
isfactory performance and may void manufacturer's
warranty.
3