Battery Substitution; Disposal - I-Tech MIO-IONOTENS Notice D'utilisation

Do not open the battery charger: it does not contain repairable parts.

Battery substitution

Remove the clip belt, then open the battery compartement on the back side of
the device. Disconnect the cable and take away the battery. Connect the cable
of the new battery, close the battery compartment and insert the belt clip.
battery longer duration:
Recharge the battery once in a month even if the device is not used;
•
• Discharge the battery as much as possible before the recharging;
• Use only the original battery charger or in any case the battery charger
supplied by the fabricant/distributor. Not open or modify the battery
charger.

Disposal

MIO-IONOTENS was designed and engineered to have minimal negative
environmental impact, in consideration of its performance and safety
requirements, following the disposition given by the European Directive
2012/19/EU, regarding the waste of electrical and electronic equipment.
Rigorous standards were followed in order to minimize the amount of waste,
use of toxic materials, noise, non-required radiation and energy consumption.
A deep research on the optimization of machine performances guarantees a
significant consumption's reduction, in accordance to the saving energy
principles.
The correct disposal of obsolete equipment, accessories and most of all of
batteries contributes in preventing possible negative consequences on human
and environmental health.
IACER Srl
WARNING. Remove the battery in case of
prolonged inactivity (over two months).
Batteries have to be handled by adult persons:
keep them out of children's reach.
WARNING. The life of the battery depends
on the number of charge/recharge cycles.
We suggest the following precautions for a
This symbol means that the product shall not be disposed
as domestic waste.
81 MNPG151-07