Electrical Warnings - Haier Chef@Home 4 Serie Mode D'emploi

• The appliance must not be installed behind a decorative door in or
der to avoid overheating.
• The oven can be located high in a column. Before fixing, you must
ensure good ventilation in the oven space to allow proper
circulation of the fresh air required for cooling and protecting the
internal parts. Make the openings specified on last page.

ELECTRICAL WARNINGS

• If the oven is provided by the manufacturer without plug:
THE APPLIANCE MUST NOT BE CONNECTED TO THE POWER
SOURCE USING PLUG OR SOCKETS, BUT MUST BE
DIRECTLY CONNECTED TO THE SUPPLY MAINS. The
connection to the power source must be carried out by a suitably
qualified professional. In order to have an installation compliant to
the current safety legislation the oven must be connected only
placing an omnipolar breaker, with contact separation compliant to
the requirements for overvoltage category III, between the
appliance and the power source. The omnipolar breaker must bear
the maximum connected load and must be in line with current
legislation. The yellow-green earth cable should not be interrupted
by the breaker. The omnipolar breaker used for the connection
must be easily accessible when the appliance is installed. The
connection to the power source must be carried out by a suitably
qualified professional considering the polarity of the oven and of
the power source. The disconnection must be achieved incorporating
a switch in the fixed wiring in accordance with the wiring rules
• If the oven is provided by the manufacturer with plug:
The socket must be suitable for the load indicated on the tag and
must have ground contact connected and in operation. The earth
conductor is yellow-green in colour. This operation should be
carried out by a suitably qualified professional. ln case of
incompatibility between the socket and the appliance plug, ask a
qualified electrician to substitute the socket with another suitable
type. The plug and the socket must be conformed to the current
norms of the installation country. Connection to the power source
can also be made by placing an omnipolar breaker, with contact
separation compliant to the requirements for overvoltage category
III, between the appliance and the power source that can bear the
maximum connected load and that is in line with current legislation.
EN 6
The yellow-green earth cable should not be interrupted by the
breaker. The socket or omnipolar breaker used for the connection
should be easily accessible when the appliance is installed. The
disconnection may be achieved by having the plug accessible or
by incorporating a switch in the fixed wiring in accordance with the
wiring rules.
• If the power cable is damaged, it should be substituted with a cable
or special bundle available from the manufacturer or by contacting
the customer service department. The type of power cable must
be H05V2V2-F. This operation should be carried out by a suitably
qualified professional. The earth conductor (yellow-green) must be
approximately 10 mm longer than the other conductors. For any re
- pairs, refer only to the Customer Care Department and request
the use of original spare parts.
• Failure to comply with the above can compromise the safety of the
appliance and invalidate the guarantee.
• WARNING: the accessible parts can become hot when the grill is
in use. Children should be kept at a safe distance.
• Do not use rough or abrasive materials or sharp metal scrapers to
clean the oven door glasses, as they can scratch the surface and
cause the glass to shatter.
• WARNING: ensure that the appliance is switched off before replacing
the lamp, to avoid the possibility of electric shocks.
• The oven must be switched off before removing the removable
parts. After cleaning, reassemble them according the instructions.
• Only use the oven for its intended purpose, that is only for the
cooking of foods: any other use, for example as a heat source, is
considered improper and therefore dangerous. The manufacturer
cannot be held responsible for any damage resulting from
improper, incorrect or unreasonable usage.
• The use of any electrical appliance implies the observance of some
fundamental rules:
• Do not pull on the power cable to disconnect the product from the
power source;
• Do not touch the appliance with wet or damp hands or feet;
• In general the use of adaptors, multiple sockets and extension
cables is not recommended;
EN 7