Haier Chef@Home 4 Serie Mode D'emploi page 6

5. Remove the temperature probe from inside the oven.
• Use only the recommended temperature probe in this oven.
STAND-BY
The oven goes in standby after 19 minutes of inactivity. To exit from
this condition the ON/OFF button has to be put in OFF and be
pressed again. Standby is not activated if:
• a cooking program is running
• the oven is waiting for a programmed cooking.
Preci Probe WARNINGS (wireless temperature probe)
• This product is exclusive for oven appliances. It should only be
used as described in this User Manual.
• DO NOT TOUCH Preci Probe WITH BARE HANDS JUST
AFTER COOKING. Always wear oven gloves to remove Preci
Probe from the food after cooking.
• It is required to FULLY INSERT Preci Probe metal bar properly
into the food until the BLACK ceramic EDGE of it during cooking.
insert Preci probe in the food up to here
Do not expose the metal part of Preci Probe to the heat
generated by oven directly. Do not expose the metal part of
Preci Probe to the heat generated by the appliance.
• Do not use Preci Probe in another appliance except for the built-
in oven.
• Do not use Preci Probe in a microwave oven.
• Preci Probe can be cleaned and washed but do not immerse it
long in water.
• This product is not intended for use by persons with ages 12
and under.
• The supplier will not be liable for any damage of Preci Probe
due to misuse of the device.
• Clean the Preci Probe before the use
• Probe can work in this range of temperature: 10 °C to an internal
EN 10
maximum temperature of 100°C of the metal part. Ceramic part
can reach 350°C.
• If the Preciprobe temperature exceeds 100°C, cooking will stop
and the Preciprobe must be removed from the oven as soon as
possible, wearing gloves, to avoid damage to the probe.
PRECIPROBE
• Be fore the use verify the charge of the Preci Probe:
1. Put Preci Probe into the charger and close the cover.
2. Connect the charger to a USB power source, such as USB
adapter or USB socket of PC/notebook with the USB cable. The
charger may not be working properly with power bank because
of its auto switch-off function.
3. LED of the charger will turn on and is flashing during charging.
It will turn off when Preci Probe is fully charged.
• Verify that Bluetooth of the oven is turned on.
• Make sure the Preci Probe is within the range of monitoring
distance. With long distances the Preci Probe cannot be detected
by the oven.
• If the Preci Probe is covered by an insulated material doses not
communicate with the oven.
If the probe is disconnected while standard cooking using the probe
is underway (flat battery, Bluetooth turned off, etc....), the cooking
process will be interrupted after a brief interval.
During cooking with recipe and probe, the cooking process continues
for the remaining scheduled time if disconnected.
During assisted cooking with PreciTaste and probe, the cooking
process continues for the last estimated time if disconnected or the
internet connection is lost.
EN 11