Jacuzzi J-200 Serie Mode D'emploi page 23

8. Place Cover On Spa
• Keeping the insulating cover in place anytime the spa is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
DANGER:
!
Check water temperature carefully before entering hot tub!
Excessive water temperature can cause burns, welts and
body temperature to rise, hyperthermia (over-heating).
Decontamination Procedure (Steps 9-16)
Steps 9-16 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable after performing steps 1-6 above (refer to the inside
cover of the manual).
9. Add 2.5 ounces of sodium dichlor for every 100 gallons of water.
Refer to the table below for approximate water fill volume by model.
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
!
Never add chlorine tablets (trichlor) or acid to your hot tub
for any reason! These chemicals may damage components
within your hot tub, burn or irritate your skin, create a rash,
and void the manufacturer warranty for your spa.
Water Fill Volume by Model
Model
J-280
J-275
J-245
J-235
J-210
*Use average fill volume for chemical maintenance
RISK OF PERSONAL INJURY.
Average Fill Volume*
460 Gal (1,741 L)
420 Gal (1,590 L)
360 Gal (1,363 L)
360 Gal (1,363 L)
240 Gal (908 L)
J-200
Sodium Dichlor
12.0 oz
10.5 oz
9.0 oz
9.0 oz
6.0 oz
19