Zebra 1 / Zebra 2
The zebra function has been enhanced in
this version, allowing you to select the
following two types of setting. Also, the
level settings can now be adjusted in 1%
increments.
• Zebra 1: Set a reference level and range for
zebra display.
• Zebra 2: Display zebra above a set level.
Setting zebra
(DISPLAY SET) menu t
Select
[ZEBRA], and set the following items.
Item
[ZEBRA SELECT]
*1
[ZEBRA1 LEVEL]
[ZEBRA1 APERTURE
*2
LEVEL]
*3
[ZEBRA2 LEVEL]
*1 Zebra 1 level (reference level)
*2 Zebra 1 range
*3 Zebra 2 level (minimum level)
When ZEBRA1 or ZEBRA2 is selected, the
icon or
icon appears.
b Notes
• Zebra 1 and zebra 2 cannot be displayed at the
same time.
• Zebra is not recorded onto the memory card.
• When [ZEBRA SELECT] is OFF, the zebra
point of the histogram is not displayed, even if
[HISTOGRAM] is set to [ON[ZEBRA POINT]]
in the DISPLAY SET menu.
z Tip
• You can assign [ZEBRA] to an ASSIGN button.
The setting switches to OFF
ZEBRA2 each time you press the button.
(Default setting in bold)
Settings
OFF, ZEBRA1,
ZEBRA2
0% to 109% (1%
increments) (70%)
2% to 20% (2%
increments) (10%)
0% to 109% (1%
increments) (100%)
t
t
ZEBRA1
High-Quality
Streaming using
NETWORK CLIENT
MODE
High-quality streaming employing Sony
QoS technology is supported in network
client mode by connecting a Sony PWS-
100RX1 Network RX Station (sold
separately) acting as a Connection Control
Manager (hereinafter, "CCM").
b Note
• Basic network configuration is required before
using this function.
For details about the network settings of the
camcorder, refer to "Configuring a wireless
LAN," "Configuring a wired LAN," and
"Resetting network settings" in the Operating
Guide.
Configuring using the menu
Select
(NETWORK SET) menu
[NETWORK CLIENT MODE]
[CCM SET], enter the following items,
and select OK.
• Host Name: IP address or host name of the
connected CCM
• Port: Port number of the connected CCM
• User: User name
• Password: Password
GB
t
t
GB
7
Continued ,