System Components Fitted To The Gate; Device Overview; Signal Indicators - ASO Safety Solutions ISK 71-242 Manuel D'utilisation

ISK 71-242 + ISK 71-942 Inductive Safety Relay

5. System components fitted to the gate

1
3 11 3
10 1 2
2 2
2
Example of use
The actual arrangement o� the individual components
depends on the design o� the gate in question and the
conditions at the installation site.

6. Device overview

6.1 Signal Indicators

LED Power (green)
Suppl�� voltage
LED Transmit Opening (red)
Fault, opening movement ‑ travelling edge(s)
LED Stationary Opening (red)
Fault, opening movement stationar�� edge(s)
LED Transmit Closing (red)
Fault, closing movement ‑ travelling edge(s)
LED Stationary Closing (red)
Fault, closing movement ‑ stationar�� edge(s)
I� no error is present, then LED Power shows the �unction control (briefl�� off). During the output o� an error
message, the number o� output pulses indicates the error:
Pulse Error message
1 Voltage suppl�� outside o� the valid value range
2 ISK transmission error
3 Output control Open �ault��
4 Output control Close �ault��
5 Data transmission with microcontroller �ault��
16
Inductive Safety Relay
2
Relay
4 3
1 ISK 71‑242 (ISK 71‑942) control device
2 Stationar�� coil core
3 Travelling coil core
4 Steel cable acting as transmission medium
ISK 71-242 ISK 71-942
ISK 71-242
Power
Transmit Opening
Stationary Opening
Transmit Closing
Stationary Closing
ISK 71-942
Power
Transmit Opening
Stationary Opening
Transmit Closing
Stationary Closing