• use a cloth soaked in neutral deter-
Plasti c
gent
(door seal
• clean with a cloth soaked in clean
profi les)
water
Aluminium • Use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C).
• Immediately remove all traces of water
or detergent using a dry cloth in order
to prevent marks from forming.
Wood
• Use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C).
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming.
• before treati ng the enti re surface,
test on a small hidden area and ver-
ify that the cleaner will not damage
the fi nish or color
20. 7 Clean the stainless steel
Certain situati ons can cause the formati on of rust on the surfaces in steel:
iron remains left on damp surfaces, limestone, chlorine or ammonia based detergents not rinsed
properly, food incrustati ons or residues, salt-saline soluti ons, dry residues of evaporated liquids.
recent stains and rust:
Remedy
clean with shampoo or neutral detergents, using a sponge or a rag.
When fi nished, eliminate any detergent residue, rinsing abundantly and thoroughly
drying the surfaces.
old stains and rust:
use chemical substances on the stainless steel that contain 25% of nitric acid or similar
substances.
persistent stains and rust:
sand with a stainless steel brush, wash with detergent and dry thoroughly.
CAUTION! Slippery fl oor. Falling.
Remove from the fl oor any items such as sponges, rags, waste of water or detergent.
Carefully clean any residue of detergent or saniti zer.
i
Carefully follow the saniti zing, rinsing and drying procedures to prevent proliferati on of
harmful bacteria.
20. 8 Inspect the parts
Once you have completed saniti zing, rinsing and drying, proceed as follows:
Pitch
1
check that all parts are perfectly clean and dry
2
check that they are not damaged or too worn
3
replace worn parts with new ones provided by the manufacturer
05060167 00 09-08-2016
This interventi on may however cause scratches to the surfaces due to the
abrasive cleaning method. DO NOT use hydrochloric acid on stainless steel
surfaces
DO NOT use waxes, concentrated detergents,
which contain oil, bleach, glass cleaners, abra-
sive detergents or fl ammable fl uids
DO NOT use acid or alkaline detergents (e.g.
bleach) which could corrode the surfaces
DO NOT use rough or abrasive materials or
metal scrapers that scratch the aluminium
surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
DO NOT use rough or abrasive materials that
could scratch the surfaces
DO NOT use steam cleaning equipment
DO NOT use rough cloths
moderate the use of liquid detergent: overuse
causes seepage and then swelling of the wood
Acti on
Lisbona 2
English
49