Clean Specific Materials; Clean The Stainless Steel - Arneg Santiago 2 Manuel D'installation Et De Service

22. 6 Clean specific materials

Material
• use a soft cloth with a neutral de-
Glass
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water and detergent with a dry
cloth in order to prevent marks
from forming and to prevent liquid
from reaching the gaskets, frame,
or the glass door hinges.
• use a cloth soaked in neutral deter-
Plastic
gent
(door seal
• clean with a cloth soaked in clean
profiles)
water
Aluminium • use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of water
or detergent using a dry cloth in order
to prevent marks from forming
• use a soft cloth with a neutral de-
Wood
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming
• before treating the entire surface,
test on a small hidden area and ver-
ify that the cleaner will not damage
the finish or color

22. 7 Clean the stainless steel

Certain situations can cause the formation of rust on the surfaces in steel:
iron remains left on damp surfaces, limestone, chlorine or ammonia based detergents not rinsed
properly, food incrustations or residues, salt-saline solutions, dry residues of evaporated liquids
recent stains and rust:
Remedy
clean with shampoo or neutral detergents, using a sponge or a rag.
When finished, eliminate any detergent residue, rinsing abundantly and thoroughly
drying the surfaces.
old stains and rust:
use chemical substances on the stainless steel that contain 25% of nitric acid or similar
substances.
persistent stains and rust:
sand with a stainless steel brush, wash with detergent and dry thoroughly.
Carefully clean any residue of detergent or sanitizer.
i
Carefully follow the sanitizing, rinsing and drying procedures to prevent proliferation of
harmful bacteria.
05060185 00 19-06-2019
Remedy
This intervention may however cause scratches to the surfaces due to the abra-
sive cleaning method. DO NOT use hydrochloric acid on stainless steel surfaces
What to avoid
DO NOT use hot water on cold glass surfaces;
the glass could crack and injure the operator
DO NOT use rough or abrasive materials or
metal scrapers that could scratch the glass
surfaces
DO NOT use dirty cloths
DO NOT use waxes, concentrated detergents,
which contain oil, bleach, glass cleaners, abra-
sive detergents or flammable fluids.
DO NOT use acid or alkaline detergents (e.g.
bleach) which could corrode the surfaces
DO NOT use rough or abrasive materials or
metal scrapers that scratch the aluminium
surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
DO NOT use rough or abrasive materials that
could scratch the surfaces
DO NOT use steam cleaning equipment
DO NOT use rough cloths
moderate the use of liquid detergent: overuse
causes seepage and then swelling of the wood
Santiago 2
English
49