Clean The Stainless Steel; Clean The Longitudinal Sliding Closures; Inspect The Parts - Arneg Ankara 4P Manuel D'installation Et De Service

Masquer les pouces Voir aussi pour Ankara 4P:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 74
Wood
• use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming
• before treati ng the enti re surface,
test on a small hidden area and ver-
ify that the cleaner will not damage
the fi nish or colour

23.6 Clean the stainless steel

Certain situati ons can cause the formati on of rust on the surfaces in steel:
iron remains left on damp surfaces, limestone, chlorine or ammonia based detergents not rinsed
properly, food incrustati ons or residues, salt-saline soluti ons, dry residues of evaporated liquids
recent stains and rust:
Remedy
clean with shampoo or neutral detergents, using a sponge or a rag.
When fi nished, eliminate any detergent residue, rinsing abundantly and thoroughly
drying the surfaces.
old stains and rust:
use chemical substances on the stainless steel that contain 25% of nitric acid or similar
substances.
persistent stains and rust:
sand with a stainless steel brush, wash with detergent and dry thoroughly.
CAUTION! Slippery fl oor. Falling.
Remove from the fl oor any items such as sponges, rags, waste of water or detergent.
Carefully clean any residue of detergent or saniti zer.
i
Carefully follow the saniti zing, rinsing and drying procedures to prevent proliferati on of
harmful bacteria.

23.7 Clean the longitudinal sliding closures

Respect the chapters 23.1., 23.2., 23.5. and proceed as described:
Step
1
lift and remove the closures, use two hands, use safety gloves (Fig.15)
2
gently place them on a fl at surface, DO NOT break or damage them
3
clean as indicated in the glass parts cleaning secti on (chap.23.5)
4
reinstall the closures

23.8 Inspect the parts

Once you have completed saniti zing, rinsing and drying, proceed as follows:
Step
1
check that all parts are perfectly clean and dry
2
check that they are not damaged or too worn
3
replace worn parts with new parts supplied only by the manufacturer
4
install the parts perfectly dry
5
restore electrical power supply
Once the internal operati ng temperature has been reached, it is possible to load the products.
05060215 00 05-2022
This interventi on may however cause scratches to the surfaces due to the abra-
sive cleaning method. DO NOT use hydrochloric acid on stainless steel surfaces
DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
DO NOT use rough or abrasive materials that
could scratch the surfaces
DO NOT use steam cleaning equipment
DO NOT use rough cloths
moderate the use of liquid detergent: overuse
causes seepage and then swelling of the wood
Acti on
Acti on
Ankara 4P - Arka 4P
English
47

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Arka 4p

Table des Matières