Kärcher KM 100/100 R Bp Mode D'emploi page 26

 Screw on new sealing strip.
 Side sealing strips
 Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).
 Screw on new sealing strip without fully
tightening the nuts.
 To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
 Adjust sealing strip.
 Tighten nuts.
 Screw on side panels.
 Push in the waste containers on both
the sides and lock them.
Replacing dust filter
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
 Turn main key to "0" and remove it.
 Press emergency-stop button.
 Open the hood, insert retaining rod.
 Pull out the filter holder to the maximum
possible extent and lock.
 Remove the lamella filter.
 Insert new filter.
 Make sure driver engages with holes on
drive side.
 Lock the handle of the filter cleaner
back into place.
Note: Make sure when installing the new
filter that the fins are not damaged.
Replacing filter case seal
26
 Lift filter case seal out of groove in the
cover.
 Insert new seal.
Checking drive belt
 Turn main key to "0" and remove it.
 Press emergency-stop button.
 Open the hood, insert retaining rod.
 Check tension of drive belt and V-belt of
the suction blower, also check for wear
or damage.
 Check tension, wear and damages on
the V-belt of the sweep roller drive.
Check cup seal
 Chek the cup seal at the suction blower
regularly to see that it sits properly.
Replacing fuses
10
-
EN
 Loosen screws on both sides of the
panel.
 Replace defective fuses.
 Replace front panel.
Note: Only use fuses with identical safety
ratings.
Pole fuse
1 Nut
2 Battery charging cable
3 Pole fuse
4 Jumper
5 Screw
 Replace defective fuse.
Note:A defective pole fuse may only be re-
placed by a Kärcher service technician or
an authorised expert.