Operation; General; Touchpad Control - Hatco Intelligent Toast-Qwik ITQ Série Manuel D'installation Et D'utilisation

English

General

The Intelligent Toast-Qwik Conveyor Toaster is designed for
ease of operation and versatility. Use the following information
and procedures to operate the toaster.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
BURN HAzARD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• Do not remove crumb tray for cleaning until toaster is
cool.
Always operate toaster with crumb tray installed.

Touchpad Control

The following are descriptions of the controls used to operate
the Intelligent Toast-Qwik Conveyor Toaster. all controls are
located on the touchpad control at the front of the unit.
Program Keys (Keys 1–5)
Each program key stores the toast settings for a custom menu
item. Touching one of the program keys starts the
corresponding menu item toast sequence. On dual conveyor
toasters, the program keys on the left side of the touchpad are
for the left conveyor, and the program keys on the right side of
the touchpad are for the right conveyor.
NOTE: The touchpad control on Model ITQ-1000-1C single
conveyor toasters have program keys labeled 1–10.
Only keys 1–5 are used for custom menu items. Keys
6–10 are used for programming functions.
Standby Key
)
The Standby ( key toggles the toaster between operation
and standby. In standby, the conveyor and elements are off and
the touchpad display is dark, but the toaster remains energized.
• From standby, touch and hold the
seconds to activate the toaster. The toaster will be ready
for operation in approximately five minutes.
• From operation, touch and hold the
seconds to shut down operation and put the toaster into
standby.
POWER SAVE Key
The POWER SaVE key puts the toaster into Power Save mode.
In Power Save mode, the toaster remains activated but the heat
level drops to a reduced percentage of the current heat settings.
When restarting from Power Save mode, the unit will be ready
to toast in approximately two minutes or less.
Form No. ITQm-0214
CAUTION
key for three
key for three
Darker Key
The Darker ( ) key allows a single item to be toasted to a
darker shade than the current menu item setting.
To use the key:
a. Place the item on the conveyor.
b. Touch the key. This key may be touched up to five
times to produce a shade five times darker than the
current menu setting.
Lighter Key
The LIGHTER ( ) key allows a single item to be toasted to a
lighter shade than the current menu item setting.
To use the key:
a. Place the item on the conveyor.
b. Touch the key. This key may be touched up to five
times to produce a shade five times lighter than the
current menu setting.
Up/Down Arrow Keys
The Up/Down arrow (
menu items, if available. The display will show each menu item
next to its corresponding program key (1–5).
Touchpad Display
The touchpad display shows the current status of the toaster as
well as operational information related to the program keys,
chamber temperature, error messages, etc...
Touchpad Display
Touchpad Control
for dual
conveyor unit.
Left
Conveyor
Keys
Right
Conveyor
Keys
Touchpad Control and Display (ITQ-1750-2C shown)
7

OPERATION

)
keys scroll through additional
1 Bun
2 Toast
3 Hash Brown
4 Product 4
5 Product 5
continued...